Grass Valley NV9603A v.1.1 - Manual (Page 26)

16
Configuration
Panel Options
These are its drop-down menu options:
Release Mode Normal Release This panel can release “locks” and “protects” set by the designated
user (at this panel or any other panel).
Force Release This panel can release locks and protects set by any user.
Default
Destination None After a reset, the panel has no default destination and displays no
destination device. (This is not recommended.)
‹device› The panel uses the specified device as the destination after a reset.
(The ‘Default State’ button also returns the panel to this destina-
tion.)
Preset Monitor None The preset source video is not sent to a monitor.
‹device› The preset source video for the selected destination appears on
the specified monitor (device).
Status Monitor None The current source video is not sent to a monitor.
‹device› The current source video for the selected destination appears on
the specified monitor (device).
Data
Routing Mode Automatic If a control (data) level is involved in the route, make the route on
the control level even if the control port is in use on the source or
destination device.
Semi-automatic
(recommended) If the control port is in use on the source or destination device, take
all levels except control and allow the user to perform the control
level route by pressing ‘Take’ a second time. If ‘Take’ is not pressed
again, the route is cancelled.
If the control port is not in use, the control level take occurs auto-
matically.
Manual A take on the data level must be performed manually as a break-
away on the control level. The control level will never switch as part
of a multi-level take.
Salvo List [none] Salvo lists appear in the drop-down menu. A salvo list, as you might
think, is a list of salvos. The salvos in the list you choose are the sal-
vos the operator can choose in salvo mode.
Salvo lists are defined, in NV9000-SE Utilities, under the ‘Views’
pane, using the ‘Salvo Lists’ table and the ‘Salvo List Details’ table.
The NV9000 configuration might not have any salvo lists, in which
case ‘None’ is the only entry in the drop-down menu.
Default Name Set System Name A list of “name sets” appears in the drop-down menu. The name
sets can be defined under the System Management pane of
NV9000-SE Utilities. Choose ‘System Name’ in this list if you do not
want, or do not care about, alternate device names. Do
not choose
‘System Name’ if you are configuring any ‘Name Set Toggle’ but-
tons.