Configuration, Summary, Adding a panel to an nv9000 configuration – Grass Valley NV9603A v.1.1 User Manual
Page 21: 4 configuration, Summary adding a panel to an nv9000 configuration, Chapter 4, Topics

11
Configuration
Chapter 4 provides configuration instructions for the NV9603A.
Topics
Adding a Panel to an NV9000 Configuration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
NV9603A Panel Configuration Page
Source Shift and Destination Shift
Single-Destination Configuration
This chapter addresses configurers. Operators and other persons not interested in NV9603A
configuration need not read this chapter.
Summary
The NV9603A is a relatively simple panel. It has 34 function buttons and a small display. It oper-
ates in X-Y mode.
NV9000-SE Utilities is the software with which to configure the NV9603A. Figure 4-1, following,
shows the default NV9603A panel configuration page from NV9000-SE Utilities.
Adding a Panel to an NV9000 Configuration
You must create configurations for the NV9603A using NV9000-SE Utilities. We assume that you
are familiar enough with NV9000-SE Utilities that you can understand the following material. It
is not difficult material, but some of the concepts might not be familiar to everyone.
It takes only a few seconds to add a new panel configuration.