Grass Valley Kalypso Emergency Bypass Option - Manual (Page 22)

22 Kalypso Emergency Bypass Option Instruction Manual
Configuration
4. Setup the keyer signals that are connected to the Keyer Module in the
Emergency Bypass frame.
• If you are using a key from the router, touch the Router button for the
keyer and enter the exact name of router destination to be used for
that keyer.
• If you are using a direct input for a key, touch the Direct button.
5. Enter the mix rate for each key, by touching the Key Mix data pad and
entering a value, or using the soft knob. The key mix rate is displayed
in seconds : frames format. The knob can be rotated to increment and
decrement the mix rate in frames. The mix rate can also be entered
from the keypad in seconds : frames format or just as frames. A value
of 0 frames causes a cut transition.
6. Touch the Enable button to enable the option. This initiates
communication between the Local Aux panel, Emergency Bypass
frame, and external Router, and activates the bypass buttons on the
Local Aux panel.
If the Emergency Bypass option is not present, but it is enabled in this
menu, pressing the bypass buttons on the Local Aux panel will display a
warning message indicating the system is not responding. If the Emer-
gency Bypass option is not present, it should be shut down in this menu to
deactivate the Local Aux panel bypass buttons and prevent display of the
warning message.
Test Emergency Bypass
You can now test Emergency Bypass operation (this should be done when
not actually on-air, of course). See
page 10 for operating instructions.