Grass Valley Kalypso Emergency Bypass Option - Manual (Page 20)

20 Kalypso Emergency Bypass Option Instruction Manual
Configuration
7. Send this configuration to the SMS 7000 system. The router is now
configured for serial communication.
Encore Router
Encore router configuration procedures are similar to those used for the
SMS 7000 system. An Encore router communicates to the Kalypso system
via an RCL client. RCL is a superset of the SMS 7000 native protocol. The
Encore serial COM 2 port is configured for RCL at the factory.
Refer to the Encore system documentation for detailed instructions. Specif-
ically, see the Encore Installation and Service Manual for information about
installing the SIO mezzanine, and see the Encore User Manual for configu-
ration instructions.
The Kalypso system must have access to the Encore router serial digital
video and key levels feeding the Emergency Bypass system.
Kalypso System
Relay Module Switch Setting
The Emergency Bypass Relay Module switch must be set to the center
Remote position before the Kalypso system will be able to control it.
Switch position up forces bypass operation, and switch position down
forces normal operation.
Specifying Shaped or Unshaped Sources
The Keyer module can be set to accept shaped or unshaped video for
keying. The same selection is applied to all sources. Settings are retained
when power to the frame is cycled.
1. Set the dial switch on the Keyer Module (slot 8) to the desired mode:
• Select 1 for shaped video.
• Select 2 for unshaped video.
2. Press the toggle switch to enact the change.
Mapping Router Sources
You need to know the exact names of the router sources and destinations
that will be used by the Emergency Bypass system. Router names are case
sensitive, with a maximum of eight characters.