Grass Valley Kalypso Emergency Bypass Option User Manual
Page 16
16
Kalypso Emergency Bypass Option Instruction Manual
Installation
3.
Attach the two closely spaced connectors on the new cable to the same
two boards in the lid (
Figure 7
). The red marked edge of the ribbon
cable must face down toward the hinge of the lid, to match the pin 1 and
2 side of the connector. These connectors are keyed for this orientation.
Figure 7. Newer Board (671-4945-03) Cable Installation
4.
An interconnecting assembly with short and long pins is provided with
the kit. If not already installed, insert the side of the assembly with the
short pins into the remaining open ribbon cable connector, making sure
all connector sockets are filled.
CAUTION Use care when connecting the ribbon cable to the Local Aux Processor Inter-
face board.The connector is not keyed, and equipment damage can occur if
the connector is installed misaligned with the pins.
5.
The remaining connector with the long pins protruding attaches to the
J2 connector on the lower left corner of the 671-4945-03 Local Aux
Processor Interface board. Orient the cable with the ribbon emerging
from the left side of the connector. The red marked edge of the ribbon
cable must face up toward the opening of the tub, matching the pin 1
and 2 side of the connector on the board.
6.
Route the cable alongside the power supply (
Figure 7
), using the
supplied adhesive cable restraints.
7.
Close the lid and power up the Main panel.
0721_07_70_r2
New Replacement
Cable
Local Aux Processor
Interface Board
(Newer Model)
SATELLIT
E PORT
S
TRANSM
IT
RECEIV
E
8 8 8
8 8 8
8 8
TRANSM
IT
GP8
GP7
GP6
GP5
GENERA
L
PURPOS
E
LEDS
GP4
GP5
GP1
GP0
RECEIV
E
SATEL
LITE P
ORTS
FAULT
INIT
RUN
XMT
C119
RCV
LINK
RTP/C
ONTR
OL PA
NEL L
AN
ACTIV
ITY
COLN
C29
3.3V
R151
R152
POW
ER SU
PPLIE
S
MENU
PROC
ESSO
R
RESE
T
R153
5V
12V
SCSI
HARD
DISK
5 6
7
8
9
0
1
2
34
Final
Cable
Routing