Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 151)

July 3, 2007 K2 Storage System Instruction Manual 151
Configuring the Level 3 storage system
Configuring the Level 3 storage system
Use the topics in this section to do the initial configuration of the Level 3 storage
system.
• “Prerequisites for initial configuration” on page 151
• “Defining a new K2 Storage System” on page 152
• “Configuring the server - Part 1” on page 154
• “Configuring RAID” on page 156
• “Creating a new file system” on page 161
• “Configuring the server - Part 2” on page 162
• “Configuring server 2” on page 165
Prerequisites for initial configuration
Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information. Also refer to
Chapter 7, “Description of K2 Storage Devices” .
Devices Prerequisite for Level 3 configuration
Control point PC Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on
Ethernet switch Ethernet cables connected
Control network IP address assigned
VLANs set up
Power on
K2 Media Server Ethernet cables connected
Fibre Channel cable connected
Software installed, as from the factory, including QuickTime 7
Control network IP address assigned
Power on for all servers
L3 RAID chassis Fibre Channel address ID assigned to RAID controller(s)
Fibre Channel cable(s) connected
Ethernet cable(s) connected
Power on
L3 RAID Expansion
chassis
(optional) Chassis address assigned (for Fibre Channel)
Fibre channel cable(s) connected
Power on