EverFocus ENVS1600 - Manual (Page 32)

ENVS800 / ENVS1600 / ENVS3200 Installation Manual
32 of 115
5.4.5 Setting - Hotline (communication settings)
This menu provides communication settings for mail, FTP, modem and phone.
These settings are mandatory for several alarm reactions in GUARD mode (Send
Snapshot to FTP, Phone call, Send SMS, Send e-mail).
E-mail
Input the following information:
server, sender’s E-mail address, E-mail’s subject title, and body
content. You may click on the Send Test Mail button to test the
settings.
Note: * indicates mandatory areas
FTP Input the following information:
server, Port, Login ID, Password, and Upload directory. According
your FTP type to enable/disable Passive mode. You may click on the
Upload Test File button to test the settings.
Note: * indicates mandatory areas.
Telephone Select the modem that the system is going to dial the info call with,
and then insert the phone number. (A modem is required for voice
transition.)
Note 1. You must use a modem with voice capability.
2. You may select a Wave format file; it will be played in the phone to
alarm the person who picks up the phone call.
GSM modem Set the Port and Baud Rate of the GSM modem device, and then
enter PIN code. You can setup the interval of send SMS message.
You may click on Test to send test SMS message.
Note: The interval is set to restrict the period of two SMS. If you set as
60 min, the SMS between 60 min would be deleted and didn’t send to
user.