Grass Valley 3e Student CameraMan - Manual (Page 24)

Chapter 3
18 CameraMan 1-CCD and 3-CCD Student Camera System Installation and Operations
Step 1
Adjust the KEYPAD ADDRESS rotary switch
(located in the battery compartment of the keypad)
so the selected setting corresponds to the setting of
the BASE UNIT ADDRESS switch on the back of
the Camera, and the front of the PRM.
See Also: For information on how to set the Base
Unit Address on your CameraMan camera, refer to
the CameraMan’s installation and operations man-
ual.
Step 2 Connect the Keypad to meet your needs.
For Wireless RF Mode (up to 60 feet):
• Install the supplied AA batteries in the Camera
Control Keypad by removing the battery door
and inserting the battery into the battery com-
partment as indicated.
• Replace the battery door.
• Press one of the PAN/TILT arrows on the keypad
and verify that the LED on the front of the keypad
illuminates. This indicates that the battery is
installed properly.
Note: If the light does not illuminate, the battery may
be installed backwards. Reverse the way the battery
is inserted, and try again. If a low battery is installed,
the keypad will emit a long beep.
Note: If the battery is inserted improperly, it will not
damage the keypad. The keypad will simply not
work.
For Hard-wired Mode (up to 250 feet):
• Remove the batteries.
• Connect a CameraMan Keypad Cable (included)
to the RJ-11 type jack located in the battery com-
partment of the Keypad.
• Connect the other end of the cable to the PVI
Com port on the CameraMan base unit.
Note: When the system is powered on, the light on
the keypad should illuminate momentarily, indicating