Grass Valley 3e CameraMan - Manual (Page 34)

Chapter 4
26 CameraMan 3e 3-CCD Camera Installation and Operations Manual
2. Verify that the camera is now facing in the direc-
tion the “FRONT” label was pointing during
mounting (see page 14).
3. If you are using the optional Camera Control
Keypad or SHOT Director, make sure its base
unit address is the same as on the camera. If
they are, verify that the camera’s PAN and TILT
functions are working properly.
Cameras 1-16 on SHOT Director correspond to
Base Unit Adresses 0-F respectively: 1=0, 2=1,
3=2... 11=A, etc.
Tip: If the camera does not move, refer to the
TROUBLESHOOTING section of the Camera Con-
trol Keypad, or SHOT Director manual.