beautypg.com

Connecting the power supply, Figure 2.7 back of camera with power, Powering on – Grass Valley 3e CameraMan User Manual

Page 28: Back of camera with power 20

background image

Chapter 2

20 CameraMan 3e 3-CCD Camera Installation and Operations Manual

Connecting the Power
Supply

FIGURE 2.7

Back of Camera with Power

Mount the Power Supply with any orientation, or on
top of a table or roll-about unit by using the following
steps.

1.

Verify that the POWER switch, on the back of the
camera, is turned OFF.

2.

Plug the 5.5mm female connector from the
power supply cord into the DC POWER jack in
the back of the camera.

3.

Connect the other end of the power supply into a
120 VAC source.

Powering On

1.

Simply switch the Power button on the back of
the CameraMan Camera.

See also other documents in the category Grass Valley Equipment: