Router network configuration page – Grass Valley Acappella v.3.1.0 User Manual
Page 60
60
Acappella — Instruction Manual
Section 4 — Software and Configuration
Router Network Configuration Page
Router Network Configuration page is used to change the IP Address,
SubNet Mask, and Gateway IP Address, of the router.
Figure 24. Router Network Configuration Page
Setting IP Addresses with Web Page
CAUTION If there is more than one panel or frame in a system, duplicate IP addresses
may exist. To resolve duplicate IP Addresses see
The IP addresses of the device can be set directly from its web page by
entering the new numbers in the
Ethernet IP:
,
Subnet Mask:
and
Gateway IP:
fields.
You will need to check
Do reset
and
Save New Settings
before the change will
take effect.
System Identifier:
Leave this setting to
Default
on an Acappella system running on its own net-
work.
If your Acappella system is running on a network shared by Prelude or
Encore systems, you can isolate them from one another by assigning dif-
ferent ports for each system. The easiest way to do this is to assign one of
the System Identifier buttons (Default, 1 - 5) to all the components of the
first system, and then assign a different button to all the components of the