Grass Valley 2030RDA - Manual (Page 15)

2030RDA Instruction Manual 15
Configuration and Monitoring
Local On-board Module Configuration
The 2030RDA module can be configured locally using the jumpers shown
in
Figure 9 . The CONF LED indicates status of the configuration process.
These components perform the following:
• Jumper J24 – sets control mode for Local only or Remote and Local.
• Jumper J25 – enables or disables the reclocking function.
• CONF (configuring) LED – when on, indicates the module is initial-
izing or processing configuration information.
Remote Control Jumper
When the jumper is placed across pins 1 and 2 of jumper block J24, module
settings are changed from the on-board jumpers only. To have both Local
and Remote access, set the jumper across pins 2 and 3.
Figure 9. Module Configuration Jumpers
Auto/Bypass Jumper
When the jumper is placed across pins 1 and 2 of jumper block J25, The
detected video signal will be reclocked at the appropriate rate. With the
jumper across pins 2 and 3 all reclocking is bypassed. This jumper can be
overridden by the remote controls.
8031_06
J24
Jumper across pins 1–2
locks out remote control
Jumper across pins 2–3
enables remote and local control
LOCAL
LOCAL & REM
1
J25
Jumper across pins 1–2
selects automatic reclocking
Jumper across pins 2–3
bypasses reclocking function
AUTO
BYPASS
1
CONF – configuration
processing LED
Remote Control Lockout
Auto/Bypass Reclocking
J24
J25