Grass Valley 2030RDA - Manual (Page 13)

2030RDA Instruction Manual 13
Power Up
A red FAULT LED indicates an error situation and, when noted with the
other indicator LEDs, can indicate a specific problem area.
Table 1 describes
signal output and LED indications for the various input/reference combi-
nations and user settings.
Table 2 provides the various output conditions possible for a given input
and module setting.
Table 1. Indicator LEDs and Conditions Indicated
LED Indication Condition
Off Normal operation
FAULT (red) On continuously Module has detected internal fault
Long flash Configuration problems, check inputs and settings
COMM (yellow)
Off No activity on frame communication bus
Long flash Location Command received by the module from a remote control system
Short flash Activity present on the frame communication bus
CONF (yellow)
Off Module is in normal operating mode
On continuously Module is initializing, changing operating modes or updating firmware
PWR (green)
Off No power to module or module’s DC/DC converter failed
On continuously Normal operation, module is powered
Signal Present
LEDs (green)
Off No input signal detected
On Input carrier signal detected
Bypass (yellow)
Off Reclocking enabled and auto-rate detection mode is active
On Bypass mode, input signal will not be reclocked
143 Mb (yellow) On Input signal is locked at 143 Mb rate
177 Mb (yellow) On Input signal is locked at 177 Mb rate
270 Mb (yellow) On Input signal is locked at 270 Mb rate
360 Mb (yellow) On Input signal is locked at 360 Mb rate
Remote Override
(yellow)
Off Module settings match those indicated by module jumpers
On Settings on the modules jumpers are overridden by remote control
Table 2. Possible Output Conditions
Input Setting Output Condition
Standard Definition SDI video Auto or Bypass Standard Definition SDI video
Other carrier Bypass Other carrier
Other carrier Auto Signal with errors
No signal or over EQ range All modes Muted