Settings display – Grass Valley 2000GEN User Manual
Page 13
2000GEN Instruction Manual
13
Remote Control and Monitoring
Settings Display
) provides controls for selecting the video
standard, the genlock mode and for making adjustments to the input
timing stream from the external reference.
The following configuration parameters are provided for the module:
•
Use
Standard Select
to choose the video standard as either
NTSC
or
PAL-B
.
The input video standard is not auto-sensing.
•
Set the
Genlock
control to lock the module to the external reference con-
nected to the reference BNC,
Enable
or
Free Run
(not locked to external
reference).
•
Set the
Frame Offset
to shift the input timing stream by frames in refer-
ence to the input signal color framing (NTSC = 0–1, PAL-B = 0–3,
Default = 0).
•
Set the
Line Offset
to shift the input timing stream by lines up to one full
frame (NTSC = 0–524, PAL-B = 0–624, Default = 0).
•
Set the
Pixel Offset
to shift the input timing stream by pixels up to one full
line (NTSC = 0–857.5, PAL-B = 0–863.5, Default = 0).
•
Set the
AES Frame Offset
to shift the AES marker in the timing stream by
VFrames for NTSC only (NTSC = 0–4, Default = 0). PAL-B is not adjust-
able (always 0).
•
Select
Recall Defaults
to recall preset factory defaults for the selected stan-
dard.
Figure 8. 2000GEN Settings Display
Use
This
Link
Set video standard
Recall factory defaults
Set Genlock mode
Set Line Offset
Set Frame Offset
Set Pixel Offset
Set AES Frame Offset