Cpe connectivity detail report – H3C Technologies H3C Intelligent Management Center User Manual
Page 111
102
•
CPE Group—Select a statistics collection range, a CPE group or ALL CPEs, from the list.
•
Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the Begin Time/End Time box and then select the begin time/end time in the calendar that
appears.
shows a CPE connectivity summary report.
Figure 9 CPE Connectivity Summary Report
CPE Connectivity Summary Report parameters:
•
CPE Group—Statistics collection range, a CPE group or ALL CPEs.
•
From To—Statistics collection time range.
CPE Connectivity Summary Report fields:
•
CPE Name—CPE names.
•
IP Address—IP addresses of CPEs.
•
Availability (%)—Ratio of the time during which a CPE was connected to the ACS to the time span
specified on the Set Parameter page.
•
Total Break Persistence (Minute)—Total duration of all the breaks that occurred within the specified
period of time, in minutes.
•
Total Break Time—Total number of the breaks that occurred within the specified period of time.
•
Break Detail (Minute):
{
LT 5—Number of breaks recovered in less than 5 minutes.
{
5 to 10—Number of breaks recovered in 5 to 10 minutes.
{
10 to 30—Number of breaks recovered in 10 to 30 minutes.
{
30 to 60—Number of breaks recovered in 30 to 60 minutes.
{
GT 60—Number of breaks recovered in more than 60 minutes.
CPE Connectivity Detail Report
A CPE connectivity detail report collects detailed CPE connectivity information about the specified CPEs
in the specified time range.
To view a CPE connectivity detail report, configure the following parameters:
•
Parameter "Begin Time" and "End Time"—Select a statistics collection time range from the list. You
can select a specific time range, such as Last Hour, Last Day, Last Week, or Last Month, or select
Custom Range, and then specify the start time and end time manually.
•
CPE Group—Select a statistics collection range, a CPE group or ALL CPEs, from the list.
•
Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the Begin Time/End Time box and then select the begin time/end time in the calendar that
appears.
shows a CPE connectivity detail report.