H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 14)

8
Installing the AP
NOTE:
The WA2620i-AGN has integrated antennas. When you install the AP,
determine whether external antennas (user-supplied) are needed.
Installing external antennas is not covered in this document.
Mounting the AP on a table
WARNING!
Do not place the WA2620i-AGN on any metal surface. Place it on a place
where there are no obstacles and good signal strength is available.
1. Attach the rubber feet supplied with the AP to the rear of the AP.
Figure 4 Attach the rubber feet
2. Place the AP on the table with the rubber feet facing down.