beautypg.com

Network requirements – H3C Technologies H3C MSR 5600 User Manual

Page 81

background image

73

Admin Status : Up State : Master

Config Pri : 100 Running Pri : 100

Preempt Mode : Yes Delay Time : 0

Auth Type : None

Virtual IP : 192.168.0.10

Virtual MAC : 0000-5e00-0101

Master IP : 192.168.0.102

The output shows that when Router A detects that the uplink fails through BFD, it decreases its priority by

20 to make sure that Router B can preempt as the master.

Static routing-Track-NQA collaboration configuration example

Network requirements

As shown in

Figure 19

, Router A, Router B, Router C, and Router D are connected to two segments

20.1.1.0/24 and 30.1.1.0/24. Configure static routes on these routers so that the two segments can

communicate with each other. Configure route backup to improve network reliability.
Router A is the default gateway of the hosts in segment 20.1.1.0/24. Two static routes to 30.1.1.0/24 exist

on Router A, with the next hop being Router B and Router C, respectively. These two static routes back up
each other, as follows:

The static route with Router B as the next hop has a higher priority, and is the master route. If this
route is available, Router A forwards packets to 30.1.1.0/24 through Router B.

The static route with Router C as the next hop acts as the backup route.

Configure static routing-Track-NQA collaboration to determine whether the master route is
available in real time. If the master route is unavailable, the backup route takes effect, and Router

A forwards packets to 30.1.1.0/24 through Router C.

Similarly, Router D is the default gateway of the hosts in segment 30.1.1.0/24. Two static routes to

20.1.1.0/24 exist on Router D, with the next hop being Router B and Router C, respectively. These two
static routes back up each other, as follows:

The static route with Router B as the next hop has a higher priority, and is the master route. If this
route is available, Router D forwards packets to 20.1.1.0/24 through Router B.

The static route with Router C as the next hop acts as the backup route.

Configure static routing-Track-NQA collaboration to determine whether the master route is
available in real time. If the master route is unavailable, the backup route takes effect, and Router

D forwards packets to 20.1.1.0/24 through Router C.

This manual is related to the following products: