Electrolux 134709300 - Manual (Page 19)

19
Reversing Door
1 Be sure you have adequate swing area before reversing door.
2 You will need a screw driver with a #2 square bit.
3 Protect flat work surface, such as top of dryer or floor near dryer,
with a soft cloth or towel.
4 Be sure dryer is unplugged from power source!
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing
could result in personal injury or even death.
A) Removing Trim Ring
1 Open door to 90 degree angle.
2 Remove and save trim plug and long,
course-thread, panhead screw.
3 Close door.
4 Rotate door trim approximately ¾” counter-
clockwise and pull ring away from door.
4 Gently place door face down on flat, covered
work surface.
3 While supporting door with the other hand,
remove 3 short, fine-thread, counter-sunk
screws.
B) Removing Door from Front Panel
1 Reopen door to 90 degree angle.
2 Remove 2 short, course-thread, panhead
screws.
Preparing to reverse door swing
Removing door and hardware
Screwdrivers with
#2 square &
straight bit
Tools needed: