Electrolux 134709300 - Manual (Page 17)

17
General installation
NOTE
A wiring diagram and technical data sheet are
located inside the dryer console.
Grounding type
wall receptacle
Power cord with
3-prong grounded plug
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
IMPORTANT
Be sure the power is off at a circuit breaker/fuse
box before plugging the power cord into an outlet.
Connect the exhaust duct to the outside 1.
exhaust system (see pages 5 through 7). Use
of a 4” (10.2 cm) clamp is recommended to
connect the dryer to the exhaust vent system.
Use metal foil tape to seal all other joints.
Carefully slide the dryer to its final position.
2.
Adjust one or more of the legs until the dryer is
resting solidly on all four legs. Place a level on
top of the dryer. The dryer MUST be level and
resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and
discard door tape.
Plug the power cord into a grounded outlet. 3.
Turn on the power at the circuit breaker/fuse 4.
box.
Read the
5. Use & Care Guide provided with
the dryer. It contains valuable and helpful
information that will save you time and money.
See the next page about performing a brief,
6.
helpful “Installation Cycle” for your new dryer.
If you have any questions during initial
7.
operation, please review the “Avoid Service
Checklist” in your Use & Care Guide before
calling for service.
Place these instructions in a location near the
8.
dryer for future reference.
Installation Instructions