Electrolux 134709300 - Manual (Page 15)

15
Water connection (Steam Model only)
Installation Instructions
Turn off COLD water supply to washer, 1.
Remove COLD inlet hose from COLD water 2.
supply and inspect for rubber washer. Replace
washer if it is torn or worn out.
Momentarily turn on COLD supply and run 3.
some water into a bucket or container to clear
any contaminants in the line.
Remove hose kit from dryer drum and inspect
4.
hose couplings for proper placement of rubber
washers.
RUBBER WASHER
MUST BE PRESENT
AND UNDAMAGED
COLD INLET HOSE
TO WASHER
RUBBER WASHERS
MUST BE PRESENT