Electrolux 134709300 - Manual (Page 18)

18 Installation Instructions
Performing Installation Cycle
If your dryer has this console:
If your dryer has this console:
Empty the dryer drum. 1.
After you plug in the dryer the first time: wake up the dryer by pressing any button, rotate cycle knob 2.
to touch up cycle, press the start button and then the cancel button.
Wake up the dryer again by pressing any button, then immediately and simultaneously press and hold 3.
both the sanitize and my favorite buttons for 5 seconds, or until the LCD display changes.
The LCD window will display 4. INSTAL CYCLE and show estimated time of cycle completion. Press the
start button. The Installation Cycle will automatically test for correct cord connection (on electric mod-
els) and presence of gas supply (on gas models). At cycle completion, the LCD window may display
INSTAL PASS!
, meaning your new dryer is properly installed and ready for use. If it prompts an action
such as SERVICE CORD, NO GAS or call service 877 435 3287, review the installation steps and make the
necessary corrections before you attempt to use the dryer.
Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up.
5.
WARNING
FIRE HAZARD
Before operating the dryer, make sure the dryer
area is clear and free of combustible materials,
gasoline, and other flammable vapors. Also
see that nothing (such as boxes, clothing, etc.)
obstructs the flow of combustion and ventilation air.
NOTE
On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the
burner does not light within 45 seconds the first
time the dryer is turned on, the safety switch will
shut the burner off. If this happens, press
cancel
and wait 5 minutes before making another
attempt to light.
After you plug in the dryer the first time: wake up the dryer by pressing any button and follow the 1.
prompts on the LCD User Interface, including language selection.
The Installation Cycle will automatically test for correct cord connection (on electric models), pres-
2.
ence of gas supply (on gas models) and free flow of exhaust vent. At cycle completion, the LCD user
interface may display INSTAL PASS!, meaning your new dryer is properly installed and ready for use. If
it prompts an action such as SERVICE CORD, NO GAS or call service 877 435 3287, review the installation
steps and make the necessary corrections before you attempt to use the dryer.
Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up.
3.
NOTE
Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to
immediately run the dryer through a drying cycle, press the
cancel button to put the
unit to sleep and then rewake it immediately to continue the normal operating mode.
NOTE
Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to
immediately run the dryer through a drying cycle, press the
cancel button to put the
unit to sleep and then rewake it immediately to continue the normal operating mode.
Please read the 6. Use & Care Guide and enjoy your new premium dryer!
Please read the 4. Use & Care Guide and enjoy your new premium dryer!