H3C Technologies H3C S5820V2 Series Switches User Manual

Page 27

[PE1] bgp 200

[PE1-bgp] ip vpn-instance vpn1

[PE1-bgp-vpn1] peer 30.1.1.1 as-number 100

[PE1-bgp-vpn1] ipv4-family

[PE1-bgp-ipv4-vpn1] peer 30.1.1.1 enable

[PE1-bgp-ipv4-vpn1] quit

[PE1-bgp-vpn1] quit

[PE1-bgp] quit

# On PE 1, display the routing information of VPN instance vpn1.

[PE1] display ip routing-table vpn-instance vpn1

Destinations : 13 Routes : 13

Destination/Mask Proto Pre Cost NextHop Interface

0.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0

30.1.1.0/24 Direct 0 0 30.1.1.2 Vlan30

30.1.1.0/32 Direct 0 0 30.1.1.2 Vlan30

30.1.1.2/32 Direct 0 0 127.0.0.1 InLoop0

30.1.1.255/32 Direct 0 0 30.1.1.2 Vlan30

127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0

127.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0

127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0

127.255.255.255/32 Direct 0 0 127.0.0.1 InLoop0

192.168.0.0/24 BGP 255 3 30.1.1.1 Vlan30

224.0.0.0/4 Direct 0 0 0.0.0.0 NULL0

224.0.0.0/24 Direct 0 0 0.0.0.0 NULL0

255.255.255.255/32 Direct 0 0 127.0.0.1 InLoop0

# Perform similar configuration on the MCE and PE 1 for VPN 2. Redistribute the OSPF routes of

VPN instance vpn2 into the EBGP routing table. (Details not shown)
The following output shows that PE 1 has learned the private route of VPN 2 through BGP:

[PE1] display ip routing-table vpn-instance vpn2

Destinations : 13 Routes : 13

Destination/Mask Proto Pre Cost NextHop Interface

0.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0

40.1.1.0/24 Direct 0 0 40.1.1.2 Vlan40

40.1.1.0/32 Direct 0 0 40.1.1.2 Vlan40

40.1.1.2/32 Direct 0 0 127.0.0.1 InLoop0

40.1.1.255/32 Direct 0 0 40.1.1.2 Vlan40