H3C Technologies H3C S6800 Series Switches - Manual (Page 17)

10
contain the VLAN. If they do not, the S-channel aggregate interface automatically denies traffic
from the VLAN that is configured on the VSI filter. The same rule takes effect on Layer 2 aggregate
interfaces associated with S-channels.
• When a filter configured on a VSI aggregate interface contains information about a VLAN, you
must not configure the filter on the same VSI aggregate interface again or on other VSI aggregate
interfaces of the S-channel aggregate interface. If you do, an error message appears.
• Activate a VSI aggregate interface after configuring a VSI filter, and deactivate a VSI aggregate
interface before removing a VSI filter.
To configure a VSI filter:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSI interface view or VSI
aggregate interface view.
interface { s-channel |
schannel-aggregation }
interface-number:channel-id.vsi-loc
al-id
N/A
3. Configure a VSI filter.
evb vsi filter [ group group-id ] vlan
vlan-id [ mac mac-address ] By default, no VSI filter is
configured.
Activating a VSI interface or VSI aggregate interface
Configurations such as traffic monitoring (see ACL and QoS Configuration Guide) on a VSI interface or
VSI aggregate interface take effect only after the VSI interface or VSI aggregate interface is activated.
When a VSI interface or VSI aggregate interface is not activated, only configure filters on the VSI
interface or VSI aggregate interface.
Activate a VSI interface or VSI aggregate interface after configuring a VSI filter, and deactivate a VSI
interface or VSI aggregate interface before removing a VSI filter.
To activate a VSI interface or VSI aggregate interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSI interface view
or VSI aggregate
interface view.
interface { s-channel |
schannel-aggregation }
interface-number:channel-id.vsi-lo
cal-id
N/A
3. (Optional.) Configure
the expected bandwidth
of the VSI interface or
VSI aggregate interface.
bandwidth bandwidth-value
By default, the expected bandwidth of a
VSI interface or VSI aggregate interface
is the default maximum bandwidth of the
physical port to which the VSI interface
or VSI aggregate interface belongs.
4. (Optional.) Restore the
default settings for the
VSI interface or VSI
aggregate interface.
default N/A