H3C Technologies H3C S6800 Series Switches - Manual (Page 15)

8
Configuring MAC address learning for an S-channel
You can manually disable the MAC address learning function for an S-channel by performing this task.
To disable MAC address learning for an S-channel:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter S-channel interface
view or S-channel aggregate
interface view.
interface { s-channel |
schannel-aggregation }
interface-number:channel-id
N/A
3. Disable MAC address
learning for the S-channel.
evb mac-learning forbidden
By default, the MAC address
learning function is enabled for an
S-channel.
IMPORTANT:
• For an S-channel with the RR
mode disabled, do not disable
its MAC address learning
function. Otherwise, the
bridge might fail to forward
traffic for VMs on the EVB
station.
• After you disable the MAC
address learning function for
an S-channel, the bridge will
discard packets with an
unknown source MAC
address.
Configuring a VSI interface or VSI aggregate
interface
Creating a VSI interface or VSI aggregate interface
A VSI interface is created on an S-channel interface through this task, and it is a subinterface of the
S-channel interface. A VSI aggregate interface is created on an S-channel aggregate interface, and it is
a subinterface of the S-channel aggregate interface. Removing an S-channel also removes all its VSI
interfaces and VSI aggregate interfaces.
VSI interfaces or VSI aggregate interfaces are typically created by a VSI manager. You can create a VSI
interface or VSI aggregate interface, or modify its Pre-Associate and Associate properties through this
task.
To create a VSI interface or VSI aggregate interface:
Step Command Remarks
1. Enter system view. system-view N/A