Ensemble Designs 6010 Four Channel 24-bit Audio ADC - Manual (Page 11)

The Quad Menu shown below has been provided to allow adjusting and monitoring all
four channels at the same time when in Quad Tracking mode. Set the parameters as
follows:
• Channel Mode - Click in the Quad On box to enable quad tracking simultane-
ously for all four channels. Note that Quad Tracking can also be enabled in any
of the previous Channel mode menus.
• Digital Ref - set all four channels for the digital output reference to match your
studio reference.
• Analog Ref - adjusts the Analog input reference level of all four channels to
-10dBu to +8dBu (in 0.5dBu steps).
NOTE: Digital and Analog Ref settings above will only be active when Quad On is
checked.
The following indicators are available in the menu below:
• Sampling Frequency - will indicate what frequency the module is locking to,
either External Lock or 48kHz (internal).
• D Clip 1-4 - Black indicates signal is below digital clipping; Red indicates digital
signal is clipping. A grayed out box indicates that digital clipping cannot occur and
analog clipping will not be indicated.
• Ref Lvl - will illuminate green when each channel is reaching the digital output
reference level chosen.
• Clip Domain - will indicate where clipping will occur (Analog or Digital domain).
6010-11
Model 6010 Four Channel 20-bit Audio ADC