Ensemble Designs 6010 Four Channel 24-bit Audio ADC - Manual (Page 10)

In the Ch 3/4 Menu shown below, set the following parameters:
• Ch 3/4 Mode - set the operating modes for Channels 3 and 4.
Choose from 2-Channel (Ch 3 and 4 will be independent), Stereo (Ch 3/4 will be a
stereo pair) or Quad Tracking (Ch 1-4 will track together). Note that if you have
set Ch 1/2 in the previous menu to Quad Tracking or the Quad On function is
enabled on the Quad Menu, this selection will default to Quad Tracking.
• Ch 3 Digital Ref - sets the Digital Output Reference level for channel 3 (in
2-Channel mode). If Ch 3/4 Mode is set to Stereo, adjustment will affect the
stereo pair, or if set to Quad Tracking, adjustment will affect all channels.
• Ch 3 Analog Ref - sets the Analog Input Reference level from -10dBu to +8dBu (in
0.5dBu steps) for channel 3 only (in 2-Channel mode). If Ch 3/4 Mode is set to
Stereo, adjustment will affect the stereo pair, or if set to Quad Tracking, adjust-
ment will affect all channels.
• Ch 4 Dig Ref - When Ch 3/4 Mode is set to 2-Channel, this will adjust Channel
4 Digital Output Reference level only. If Ch 3/4 Mode is set to Stereo, adjustment
will affect the stereo pair, or if set to Quad Tracking, adjustment will affect all
channels.
• Ch 4 Analog Ref - When Ch 3/4 Mode is set to 2-Channel, this will adjust
Channel 4 Analog Input Reference level only. If Ch 3/4 Mode is set to Stereo,
adjustment will affect the stereo pair, or if set to Quad Tracking, adjustment will
affect all channels.
Refer to the Sampling Frequency, Clip Domain, Ref Level and D Clip indicator
explanations in the previous menu.
Model 6010 Four Channel 20-bit Audio ADC
6010-10