Ensemble Designs 6030 Video-Reference AES/ Word Clock Generator - Manual (Page 6)

Model 6030 Video-Referenced AES/Word Clock Generator
6030-6
INSTALLATION
Plug the 6030 module into any one of the ten slots in the frame and install the plastic
overlay provided onto the corresponding group of rear BNC connectors associated with the
module location. Note that the plastic overlay has an optional adhesive backing for
securing it to the frame. Use of the adhesive backing is only necessary if you would like
the location to be permanent and is not recommended if you need to change module
locations. This module may be hot-swapped (inserted or removed) without powering down
or disturbing performance of the other modules in the system.
CABLING
Refer to the backplane diagram of the module below for cabling instructions.
Connect an external NTSC or PAL
composite video, color black or
sync signal to the Video In BNC if
using an external reference.
NOTE: Sync minimum of 250 mV.
Signal level maximum of 2 V p-p.
Connect output destinations
to the six AES Out BNCs.
Connect an alarm to the
15-pin connector to
indicate loss of external
reference. Refer to the
pinout below:
Connect output
destinations to the
two WCLK output
BNCs.
1
6
11
15-pin High Density Connector
Alarm Pinout
Wiring Side-Male Plug
5 V@20 mA Ground
Open Collector to Gnd