Ensemble Designs 7600 HD/SD Embedder/Disembedder - Manual (Page 17)

Use the Aud Out menu shown below to adjust the following audio output parameters:
• Audio Embed A – turn embedding Off for no embedding to take place in the
output signal. Select Replace to replace the targeted group in the stream with new
content. If there is no such group already present, the new content will be placed in
the horizontal interval in normal cascade, following any other content already
there. When Cascade is selected, the audio channels are placed after any existing
content. Replace All will strip all of the original content and the new content is
placed at the beginning of the horizontal interval.
• Audio Embed B – identical to Audio Embed A but no Replace All function is
required as this will occur upstream in the A embedder.
• Mux Group A – select the multiplexed group to be embedded in embedder A in the
output.
• Mux Group B – select the multiplexed group to be embedded in embedder B in the
output.
• Dig Ref Level – set the digital reference level for the audio output.
The Memory menu shown below allows you to save overall module setups to five memory
registers as follows:
• Select Save, then one of the five memory registers Reg 1 – 5. The box will turn
green. The entire module setup is now saved in the selected register.
• To recall a register, select the register box. If there is information saved, the box
will turn green. The saved setup will now be loaded to the module. Up to five
different module setups can be saved and recalled using the individual registers.
Model 7600 HD/SD AMD
7600-17