Eneo VHM/ZLB-W User Manual
Page 20
0
F, A Front panel,
Unscrew the front section
F (with the glass pane) from housing centre section A.
housing centre
section
H
Heater plate
Screw heater plate
H onto front section F. The resistors must face the glass insert.
f, r
Screws,
To do this, use the screws
f and spacer pins r (8mm) from the pack supplied as shown
spacer pins
on the diagram.
S
Cable duct
Feed the power supply connection from the heater plate through cable duct
S and
connect it to the terminal board in the rear section of the housing.
6. Assembling and connecting the heater kit
6.1 Assembling the VHM/H24W 24V heater kit (Art. No. 71602)
Note: The VHM/H24W heater kit is premounted at VHM-ZLB-W and VHM-ZLKCB-W.
A
S
H
F
r
f
r