ATL Telecom IP-3092 IP Communicator User Manual
Page 5
Page 5
MOCET IP3092 Communicator Quick User Guide
Figure 1. To Set up the Communicator with a proper stand angle
[Remark]:
At the beginning, the hinge of IP3092 stand is placed at 0
o
. To adjust the
stand position, you have to open the first latch of hinge by putting a little
bit strong strength to pull out the stand. When you opened the first latch
of hinge, the stand is placed at 30
o
position. Then you can adjust the
stand angel at any position from 30
o
to 120
o
, so that you can find the
most convenient viewing angle by adjusting your iPad at any tilt angle
from 30
o
to 75
o
Connect the Power:
- Then plug the barrel plug of the included power adapter to the port
marked 12VDC.
Please make sure you use the right power adapter. It shall have a label showing 12V and
2A.
- Then plug in the other end of power adaptor to the wall power AC power outlet. Then you
can see LEDs on the Communicator will light up momentarily and then the Communicator
will boot.
Figure 2. The Back Panel of the Communicator and How To Connect