Introduction, Hardware installation – ATL Telecom IP-3092 IP Communicator User Manual
Page 4

Page 4
MOCET IP3092 Communicator Quick User Guide
Introduction
The MOCET™ Communicator™ is an innovative accessory for the Apple™ iPad™ that will
enable you to use your iPad as your desk phone with popular APPs including FaceTime™ and
Skype™.
Use the high definition audio-enabled handset and speakerphone on the Communicator to
enhance your communication and ensure privacy and comfort. For small office use, an external
desktop microphone can be attached improving the conference call experience. The enhanced
dynamic range stereo speakers make listening to music and watching music a more engaging
experience.
The Communicator stand is adjustable between 30º and 75º, allowing you to find the most
convenient viewing angle for watching movies or participating in video conferences. The
Communicator can fast charge and power your iPad for all day work and play. And the USB port
can offer charging to your iPhone of Mobile phone.
Bluetooth-enabled iPad/iPhone/ Android Pad/ mobile phones can be paired with the
Communicator allowing calls to be directed to the handset or speakerphone for better call
quality and comfort as well.
The Communicator supports more specifications and functions, especially a powerful
embedded VoIP engine. But if you are a regular App-oriented user, please don’t care for
them below.
(1) One micro-SD and one USB host port port on the IP3092 which allows user to connect
WiFi dongle, keyboard or other supported device.
(2) Two 10/100 Ethernet ports on Communicator allow you to connect your computer as a
pass-through to your network, requiring only one Ethernet cable to your switch or router
for both.
(3) The IP Commander App can be downloaded from the App stores can support the
operation and control of VoIP function which is embedded in the IP3092.
Hardware Installation
The Communicator comes with all the accessories needed to get going right away. Included
in the box are Quick Guide, the handset, handset cord, power supply adapter, and an
Ethernet cable. Please check on the Communicator and proceed the following sections of
this Quick Guide.
Set Up the Communicator:
- Unpacking the package box, place the Communicator on the table and turn its stand to a
proper angle (say 45 degree, please see Figure 1).
- Then connect the handset to the curly handset cord first and plug the other end of the cord
to the phone jack marked HAND
on the rear panel of the Communicator. Please refer to
the Figure 2 and the back shell ports of the Communicator.