beautypg.com

Software installation, Installing the commander app on your ipad – ATL Telecom IP-3092 IP Communicator User Manual

Page 11

background image

Page 11

MOCET IP3092 Communicator Quick User Guide

Software Installation

If you are not a VoIP user, you can skip this section, no need to install the Commander app.
However, the system will always display a dialog box for asking you to install the
Commander app if you haven’t installed the app in your iPad. To avoid this kind of
disturbance from the system, we suggest you to install the Commander app for no-use by
following below procedures.

If you are a VoIP user, please refer to the “IP Commander for iOS VoIP User Guide”.

Installing The Commander App on Your iPad

When an iPad is inserted into the Communicator, the Communicator will scan the iPad to
determine whether it has been connected to the Communicator and whether it has the
Commander app installed. If this is the first time you have connected your iPad to the
Communicator, and you do not have the Commander app, a dialog box will display saying
“This accessory requires an application you do not have” and “Would you like to install it
from App store?”

Please press the “Yes” button. Then the iPad will lead you to iTunes store to dowload the IP
Commander app. Then you have to confirm the “install” on your iPad.

If more than one iPad share one Communicator, the download and install process will be
repeated for each new iPad docked.

After install OK, please must keep the IP Commander APP there in the iPad. If you delete the IP
Commander APP, you need to do the download and install procedure again. If any upgrade is
notified, please update it. Then you don’t need to care for this IP Commander App, if you are
just an APP user. IP Commander is mainly designed to let user to run VoIP mode and operate
the embedded VoIP functions.