Archgard 31-DVIM33C - Manual (Page 8)

31-DVIM33C
8
The control panels can be mounted in the following different ways. They are shipped in the “Controls In” configuration. They can be
moved to the “Controls Out” configuration by removing the two mounting screw on each side and swinging the panels out and replacing
the screws. They can also be disconnected and placed remotely within the limits of the gas connections and electrical wiring making
sure to place them away from any heat source over 150 degrees Fahrenheit or 65 degrees Celsius
Use Shallow Trim
Use Deep Trim
Fig 8-A
Fig 8-D
Fig 8-C
Fig 8-B
Fig 8-E
LEFT RIGHT
REAR
FRONT
FRONT
Fig 8-F
CONFIGURE THE FIREPLACE - CONTROL PANEL LOCATIONS
31-DVIM33C