Archgard 31-DVIM33C - Manual (Page 24)

31-DVIM33C
24
INITIAL OPERATION
1. Check that the appliance is properly vented and connected to the gas supply.
2. Check that the media is properly placed.
3. Check that all external parts, such as door and faceplate are properly attached and fastened.
4. Do not operate this appliance with broken, cracked glass doors or without the door (s) in its
correct (and latched) position. Do not abuse the glass by either striking or slamming shut.
5. Check that there are no fingerprints left on glass panels, as high temperature can bake these
prints on permanently.
FINAL INSTALLATION CHECK
Each Archgard Gas Fireplace is checked and tested at the factory prior to being packaged and
shipped to our dealers and finally installed in your home. Archgard recommends that before leaving
this unit with the customer, the installer must ensure that the appliance is firing
correctly and that the electrical system is in working order. This will include:
1. Perform leak tests of supply line, gas control valve, supply line from gas control valve and pilot
assembly.
2. Clocking the appliance to ensure the correct firing rate (see page 9 of this manual).
3. If required, adjusting the primary air to burner to ensure that the flame does not carbon or soot.
4. Check for proper operation including correct drafting.
5. The fireplace should be turned ON for a sufficient time to ensure that the fan is working correctly.
After the system has been checked and confirmed that the fan is in working order, refer to the in-
structions for FIRST FIRE located in this manual.
As a reminder, a TAG is attached to all of our gas fireplaces. This TAG is located at the gas control
valve. See Fig 1.
ARCHGARD INDUSTRIES LTD.
*** INSTALLER ***
IMPORTANT NOTICE
ALL GAS AND ELECTRICAL CONNECTIONS
** MUST ** BE CHECKED AND TESTED AT
TIME OF INSTALLATION.
Fig 24-A
N O T E
Any alteration to our product that causes carbon or soot deposits that results in any
damage or requires cleaning is not the responsibility of the manufacturer.