Archgard 72-DVT30N - Manual (Page 30)

72-DVT30N
30
OPTIONAL BRICK PLACEMENT
WARNING: Failure to position the parts in accordance with these diagrams or failure to use
only parts specifically approved with this appliance may result in property damage
or personal injury.
The Archgard brick and reflective glass panels offer a variety of looks to customize your fire-
place and are purchased seperatly. Care must be given when first installing the bricks, and if
removed for servicing, as they can be damaged or broken if not handled properly.
After opening the brick or reflective glass panels set package, inspect to ensure that no damage
has occurred inside the package. Please report any damage immediately to your Authorized
Archgard Dealer.
Gas and vent connections must be made before installing the brick and reflective panels.
NOTE: Improper placement of panels may cause sooting on the internal parts and glass, and
will not be covered under warranty. Do not use broken or damaged logs.
The fireplace has panel mounting brackets already in place. Remove the brackets before in-
stalling the panels. Locate the brick or reflective panels and place them in the firebox as
shown. Refer to the pictured instructions on the following pages that will show how to place the
panels.
NOTE: Installing the panels in any other position other than shown will result in flame im-
pingement causing sooting of the logs, brick liner and ceramic glass viewing area.
Rear Brick Panel Placement as Shown
1st Panel