Airmar H2183—Heading Sensor - Manual (Page 6)

6
Cables & Connecting/Converting Hardware
The Heading Sensor can be connected in several ways. You must have the
correct cable and any needed hardware before beginning the installation.
Sensor Cables Length Part No.
• NMEA 0183 Cable 10m 33-862-02
• NMEA 2000® Cable 6m 33-1029-02
• NMEA 2000® Cable 10m 33-1104-01
NOTE: Additional cable lengths are available.
Connecting/Converting Hardware Length Part No.
• NMEA 0183 to USB, Data Converter 33-801-01
• NMEA 0183 to USB Combiner NDC-4-AIR
• NMEA 2000® CAN to USB, U200 Gateway 33-727-01
• NMEA 0183 & NMEA 2000® Splitter 15m 33-632-01
• NMEA 0183 & NMEA 2000® Splitter 30m 33-632-02
Tools & Materials
Safety goggles
Dust mask
Torpedo level
Pencil
Electric drill
Drill bits and hole saws:
Pilot hole 3mm or 1/8"
Bracket screw holes 4mm, #23, or 9/64"
Flush mount stud holes 6mm or 1/4"
Flush mount cable hole 38mm or 1-1/2"
Phillips screwdrivers
Marine sealant (aluminum hull)
Loctite® 242® or other removable thread locker (Flush Mount installation)
Deck gland (some installations)
Grommets (some installations)
Cutting pliers (some installations)
Heat-shrink tubing (some installations)
Heat gun (some installations)
Wire strippers (some installations)
Multimeter (some installations)
Cable ties (some installations)
Where to Purchase Parts
Lost, broken, or worn parts should be replaced immediately. Obtain parts from
your instrument manufacturer or marine dealer.
Gemeco
Tel: 803.693.0777
(USA) Fax: 803.693.0477
Email: [email protected]
Airmar EMEA Tel: +33.(0)2.23.52.06.48
(Europe, Middle East, Africa) Fax: +33.(0)2.23.52.06.49
Email: [email protected]