AEC Econo-Cool Chillers User Manual
Page 51
Page 50
AEC Water Temperature Control Units
10.
Use short presses on the
Display
key to display each
parameter within a mode.
The
SV
readout displays the different values for the parameter
within a mode.
11.
Press the
Down Arrow
key to lower values of a
parameter; press the
Up Arrow
key to raise values of a
parameter.
12.
Press the
Display
key for about two (2) seconds to
move up a level back into the different modes.
13.
Press the
Down Arrow
key until Level 0 displays.
14.
Press the
Display
key for about two (2) seconds to go
to Operating mode.
E5CK Factory Setting for Process Temperature
15.
Remove controller from housing and check for output board
number E53-R4R4 (Relay/Relay).
16.
Make sure jumper setting for input type is set for thermocouple
TC-PT, middle jumper.
17.
Return controller to housing.
18.
Press the
Display
key for one (1) second to enter Menu
Display.
19.
Press the
Up Arrow
key to get to Setup mode; the
screen displays the
message.
20.
To switch parameters within Setup mode, press the
Display
key.