ACTi INR-310 - Manual (Page 9)

Standalone NVR QIG 9
CONNECT THE DEVICES
The example below displays a network consisting of only INR, network cameras
and required peripherals. Please remember to enable the DHCP service on your
router for INR to obtain an IP assress automatically.
Switch
Cameras
Note
To assign a static IP address to INR,
enter Windows and configure the
network settings in Network and
Sharing Center.
Power Source
eSATA Storage
USB Devices VGA Monitor
ATTACH THE DUST COVER
After you finish configuring INR system, remember to lock the disk trays using
the provided keys and attach the dust cover to the unit’s front panel.
Step 2
Press the latch and push the right
end towards the unit’s right handle
until it clicks into place.
START-UP
1. (For INR-330) On the unit’s rear panel, press
down the Power Switch to the side with “ l ” mark.
2. On the unit’s front panel, press down Power Button to turn on the unit.
3. As this unit starts up, you will enter Windows logon screen, and input the pass
word “123456“ to log in as administrator.
Step 1
Align the left end hooks to the
holes on the unit’s left handle.