ACTi INR-310 - Manual (Page 8)

8 Standalone NVR QIG
RACKMOUNT THE UNIT
This unit is designed to be mounted on a standard server rack, which
occupies 2U (3.5″) of vertical space.
1. Allow a minimum of 5 cm clearance at
the front and the rear for front-to-back
airflow of the unit.
2. Prepare a rack shelf rated for the unit’s
weight or purchase the rail kit from ACTi,
and install that to support the entire unit.
3. Secure the unit onto the rack.
INR Sliding Rail Kit
HARD DISK INSTALLATION
REMOVE THE TRAY
Step 1
Slide the lock tab aside,
and the hinge tab will
pop out by itself.
Step 2
Hold the tab lever and
pull out the tray.
INSTALL THE TRAY
Step 4
Place your thumb on the
lock to push the tray into
position in the chassis.
Step 5
Press the hinge tab until
it clicks into place.
MOUNT THE DISK
Step 3
Loosen the two screws on the
tray to remove the dummy
disk. Secure the hard disk on
the tray with the provided disk
screws. Make sure the disk
connector faces towards the
SATA contacts inside the unit.
Make sure this unit is turned off, and insert the hard disks into the disk bays
following the sequence of tray numbers.