Step 2: open the dome cover – ACTi Outdoor Mini PTZ Dome on Dropped Ceiling User Manual
Page 4
Installation Guide
Step 2: Open the Dome Cover
NOTE:
To avoid scratches or leaving fingerprints on the dome cover, it is recommended to retain
the plastic covering the dome cover until the camera is completely installed. However, the plastic
has been removed on some of the pictures in this documentation to show clarity of the
procedures being described.
1.
If the cables will pass through the surface,
remove the metal cap covering the bottom hole
of the camera, and attach the cap to the side hole to close it. The cables will be routed to
pass this hole from the surface.
2.
With the bundled hex screwdriver, loosen the three (3) screws securing the dome cover.
3.
Carefully lift to open the dome cover and place it on the side of the camera.
NOTE:
Do not abruptly lift the dome cover; it is attached to the camera with a spring wire.