ACTi Outdoor Mini PTZ Dome on Dropped Ceiling - Manual (Page 17)

www.acti.com
Installation Guide
17
Appendices
This section describes the procedures in removing and installing the camera module to install a
memory card and connect external devices.
How to Remove / Install the Camera Module
How to Remove the Camera Module
The camera module must be removed from the housing in the following situations:

To install a memory card

To connect a digital input / output device

To connect an audio input / output device
Perform the steps below to remove the camera module from the housing.
1. Using the bundled hex screwdriver, loosen the three (3) screws to open the dome cover.
2. Using a standard Phillips screwdriver, loosen the three (3) screws securing the camera
module.
3. Lift to remove the camera module from the housing.