ACTi Outdoor Mini PTZ Dome on Dropped Ceiling - Manual (Page 3)

www.acti.com
Installation Guide
3
Installation Procedures
This section describes the procedures in installing the camera on a flat surface such as the
ceiling. Before installation, make sure the ceiling can bear more than the weight of the camera.
Step 1: Drill the Holes
Before drilling the holes on the ceiling, note the direction of the connectors side of the camera,
which is also the opposite side of the camera logo. This influences the camera placement and
where you should drill the hole where the cables will pass through or how the cables will go along
the ceiling.
1. Attach the supplied drill template on the surface according to the preferred camera
orientation.
2. Determine how the cables will be routed: pass through the surface or along the surface .

If the cables will pass through the surface , drill the cable hole and the three (3)
screw holes on the surface.

If the cables will be routed along the surface , just drill the three (3) screw holes on
the surface.
3. Detach the drill template from the surface and insert the plastic plugs into the screw holes.
Cable hole