ACTi Outdoor Dome (B8xI8x) on Tilted Wall with Gang Box Converter - Manual (Page 8)

www.acti.com
Installation Guide
8
Step 4: Install the Gang Box Converter
The Gang Box Converter can be attached to the gang box by either of the following orientation:
The gang box will be on the upper side of the
converter. This orientation is recommended if
the camera is installed indoors or the gang
box is installed inside the wall.
The gang box will be on the lower side of the
converter. This orientation is recommended if
the gang box is installed on the wall and the
cable be routed along the wall. This way, the
cable will be routed with a downward position
which will be an added protection against
possible water leak.
Determine the most appropriate orientation for your installation environment.
NOTE: The succeeding procedures and images show how to do the camera installation with a
gang box installed inside the wall; same procedures apply if the gang box is on the wall.
1. Route the network cable to pass through the cable hole of the gang box converter.
NOTE: The image below shows the flex conduit through the gang box converter, same
procedure applies when using the naked cable.