Eclipse - Fujitsu Ten AVN2210p - Manual (Page 6)

Switching Audio Control Modes
BASS MID TREB BAL FAD NON-F NF-P LPF LOUD SVC
BASS ...
Turn the [VOL] rotary knob to the right or left in the audio mode while referring to the table below to adjust the
sound.
1 Modes will switch in the order shown below each time the [ENTER] button is
pressed.
Mode Function [VOL] rotary knob/Function
BASS Adjusts bass level.
Turn to the right Emphasizes low sounds.
Turn to the left Softens low sounds.
MID (MIDDLE) Adjusts middle level.
Turn to the right
Emphasizes mid range
sounds.
Turn to the left
Softens mid range
sounds.
TREB (TREBLE) Adjusts treble level.
Turn to the right
Emphasizes high
sounds.
Turn to the left Softens high sounds.
BAL (BALANCE)
Adjusts left/right
(BALANCE) speaker
balance.
Turn to the right
Emphasizes right
speakers.
Turn to the left
Emphasizes left
speakers.
FAD (FADER)
Adjusts front/rear
(FADER) speaker
balance.
Turn to the right
Emphasizes front
speakers.
Turn to the left
Emphasizes rear
speakers.
NON-F (NON-FADER
LEVEL)
Adjusts non-fader
level (for connected
sub-woofer).
Turn to the right
Increases the sub-woofer
level.
Turn to the left
Decreases the sub-
woofer level.
NF-P (NON-FADER
PHASE)
The merger of sound
between the front and
rear speakers and the
woofer can be
improved by selecting
the phase. Switch the
phase which lets the
speakers combine
without any
disharmony.
Turn to the right
NORMAL
(Make the output timing
of the front/rear speakers
and the woofer the
same.)
Turn to the left
REVERSE
(Change the phase of the
output timing of the front/
rear speakers and the
woofer.)