Eclipse - Fujitsu Ten AVN2210p - Manual (Page 11)

ATTENTION
• Pressing the preset switches ([1] to [6]) allows you to make one-touch station selections. The
frequency of the selected station is displayed on the preset switch.
• When a new station is set in memory, the station previously set in memory will be deleted.
• If there are fewer than six receivable stations, the stations set in the remaining switches will
remain unchanged.
Preset Station Scan
This function enables reception of all the stations in the preset switches to be played for five seconds
each.
"P SCAN" will be displayed and the stations memorized for preset channels P1 to P6
will be called up in order and received for five seconds each.
To cancel the preset scan, press the [FUNC] button.
CAUTION
If the vehicle's battery is disconnected (for repairs to the vehicle or for removing the main unit), all
stations in memory will be lost. In such a case, set stations in memory again.
1
Press the [FUNC] button to establish the FUNCTION mode.
2
Press the [FUNC] button until the sub display switches to P SCAN.
3
Press the [ENTER] button.