Westermo RM-455U-D - Manual (Page 78)

Appendix A Response Codes
Man_455U-D Rev 3.04 Page 79
5 Watt Radio .500 mW Radio
\P0 Set Radio to 500 mW Set Radio to 10mW
\P1 Set Radio to 1 W. Set Radio to 25 mW
\P2 Set Radio to 2 W Set Radio to 100 mW
\P3 Set Radio to 5 W. Set Radio to 500 mW
AT\K Break signal handling control (Currently not implemented)
AT\B command
from online
Host sends break on serial Receive break from
remote
\K0 Purge Buffers &
send break Enter command state & purge
buffers. Don’t send Break. Purge buffers and send
break to host.
\K1 As for \K0 Purge Buffers and send break As for \K0
\K2 Send Break ahead of
buffered data. As for \K0 Transfer break to host
ahead of buffered data.
\K3 As for \K2 Send break ahead of buffered
data. As for \K2
\K4 Queue Break behind
buffered data. As for \K0 Queue Break behind
buffered data.
\K5 As for \K4 Queue break behind buffered
data. As for \K4
AT\S Radio Statistics
\S Display stats including last received signal strength from all module addresses –
1 – 127 (only modules that have been received are displayed).
1 Rssi: -98dBm Rx: 95 Fwd: 0 Err: 72 Last: 0d03h19m18s
Stats are: Last Received signal strength, Number of Messages Received from this
address, Number of messages Forwarded from this address, and Number of
received messages with errors from this address. Also indicates the time since
last received a message from this address.
\Snn Display Stats for remote number nn only
AT\T Inactivity Timeout – Units Seconds. Value 0-255. 0 = Disable. If there is no
activity within this time, the modem drops the connection. See also S Register
S6.
Appendix B Response Codes
Response codes display the status of the module in response to user commands. The response
code displayed depends on the ATV setting, the ATX setting and the ATQ setting. ATV0
selects numeric response codes. ATV1 selects verbal response codes. The ATXn command