Welltech LP-388 Mar-05-2007 - Manual (Page 85)

LAN Phone 388 User’s Manual 84
11. [flash] command
This command will clean the configuration stored in the flash rom to default value and
reboot the SIP Phone 388.
Note:
1. After user upgrade new software version, suggested to execute this command
to make sure new software work well on SIP Phone 388.
2. a. flash –clean: all data will return factory setting, except Network & SIP
configuration.
b. flash –clean all: all data will return factory setting, except Network
configuration.
12. [sysconf] command
1. -print: display all current configurations.
2. -idtime: set the duration(in second) of two pressed digits in dial mode as timed out.
If after the duration user hasn’t pressed next number, SIP Phone will dial
out all number pressed.
3. -keypad: set DTMF type .User can select DTMF type SIP Phone receive and
transmit.( sysconf –keypad 0/1 , 0 for in band ,1 for RFC2833.)
4. -2833type: change RFC2833 Payload type.