Welltech LP-388 Release 103 - Manual (Page 88)

LP388 User’s Manual 87
5. -eod: select end of dialing key, e.g. set end of dial key as “＊” button , after finished
pressing dialing number then press “＊” will dial out. (sysconf –eod 0/1/2 , 0
for no end of dial key , 1 for “＊” button, 2 for “#” button )
6. –privacy: this function can only work in Japan and also user’s service platform
supports Japan standard telecom CLIR specification. When this function
is set as Japan mode, other users can hide their caller ID by press special
code before dial out phone number.
7. –phone: set in SIP message to add user=phone parameter or not. If user enables
this function, in SIP message will add this parameter.
8. –private: Enable this function. When making call, the line number will be changed
to “private”. But PX must be supported this function.
9. –reject: when LP388 receive “private” call, LP388 will reject this invite.
10 –ringtime: Reject the call after the time. (default: 120 seconds. 0: Off)
11. –waiting: User can enable or disable Call Waiting function.
12. –transfer: User can enable or disable Transfer function.
13. –pick: Set Call Group Pick up Code. After setting this code, user can do Group
Call Pick Up with this special code.
14. –spick: Set Call Specific Pick up Code. After setting this code, user can do Single
Call Pick Up with this special code
15. –lock: Enable Keypad lock function (default: off. 0/1 off/on)
16. –lockpwd: Password of keypad.
17. –park: Set Call Park Code. Set special access code for Call Park function.
18. –mwi: Enable/Disable MWI function and specify MWI method to be client or
server-based. (0: OFF, 1: Client(Subscribe),2: Proxy(NOTIFY))
19. –mwiexpires: If user set MWI method as client-based. Here can define the
interval time of phone to send subscribe message to check voice mail.
20. –mwinumber: Set voice mail box number.
21. –atanswer: enable/disable auto answer function of Phone. If this function is
enabled, phone will answer incoming automatically.