Wavetronix Click 510 (communication tester) (CLK-510) - Quick-reference Guide - Manual (Page 2)

3
Use on-device configuration features
Next, use the device’s configuration features to make sure the Click
510 is wired and working properly. The Click 510 has four LEDs
that monitor device activity and help you select tasks and operat-
ing modes. It also
has two banks
of LEDs: one of
yellow LEDs that
represent sub-
menu 1 and one of
red for submenu 2.
It also has a push-button, labeled Mode Switch, also used
for tasks and operating modes.
1 Check the LEDs to make sure the device has power.
2 Select the baud rate for the device by autobauding as outlined below. If you’d rather manually set the
baud rate, see Part 5 below.
Yellow LEDs
Red LEDs
Multicolored LEDs
Button
Main Menu
Sub Menu 1
Sub Menu 2
LED activity-indicating functions:
Red – Shows device has power
Green – Shows device is transmitting data
Yellow – Shows device is receiving data
The blue LED has no activity-indicating function
4
How to use the push-button to navigate through mode and task menus
Select a task or operation function by navigating though the main menu (multicolored LEDs) and the sub-
menus (yellow and red LEDs) using the push-button as described below:
1 Enter the main menu and cycle through it by
holding the push-button down.
2 Release the push-button once the cycle reaches
the desired function.
3 Press the push-button again to select the func-
tion. Once selected, the function will either
start running or the first submenu (yellow
LEDs) will start.
4 Hold the push-button to cycle through the first
submenu.
5 Release the push-button once the desired sub-
menu selection is displayed.
6 Press the push-button again to select the func-
tion. Once selected, the function will either
start running or the second submenu (red
LEDs) will start.
7 Hold the push-button to cycle through the
second submenu.
8 Release the push-button once the desired sub-
menu selection is displayed.
9 Press the push-button again to select the func-
tion. The function will now run.
LED task-indicating functions (operating mode functions will be covered later):
Selection Operating mode Running Completed
Autobaud – Hold the push-button down. Release it
when green LED is solid, then press quickly once, to
autobaud to sensor.
failure: will return to
previous mode
success
(will then
return to
previous mode)
Reset – Hold the push-button down. Release it when
red LED is blinking, then press quickly once, to reset to
factory defaults.