Wavetronix Click 304 (RS-232 to RS-485 converter) (CLK-304) - Quick-reference Guide - Manual (Page 3)

5
Install Click Supervisor
Note. Your device is now fully functional. If you don’t wish to make any other
changes to configuration, you don’t need to follow the rest of the steps. How-
ever, the device can be further configured using Click Supervisor, software
available from Wavetronix. Click Supervisor will enable you to view and change
certain settings that mostly help in identifying your device.
If you would like to install Click Supervisor, follow these steps:
1 Download the setup file from www.wavetronix.com (under Support).
2 Double-click on the file to run the setup wizard. Follow the steps to install.
6
Make a connection
1 Make sure there is a connection between the device and the computer that
Click Supervisor is on. This can be through the DB-9 connector on either
module, the USB port on the Click 305, or through another device also on
the T-bus.
2 Run Click Supervisor and select Communication. This screen lets you
pick the type of connection you want to make, serial or IP. The devices will
mostly likely be configured using serial communication.
3 Click Settings to make any necessary changes to the settings, such as the
port or the baud rate. Click OK to return to the Communication screen,
then click Connect. Keep the Click ID set to 0.
4 In the next screen, Click Supervisor will display all the devices it discovers.
When the device appears, select it and click Select. Click Supervisor will
connect to the device.
7
Select a driver
1 Select Setup Click on the main screen. You will see the following two driv-
ers:
˽ SmartSensor – This driver is used if you plan on connecting from a TOC
to your device to your sensor. You can use this driver to view and change
certain basic functional and informational settings such as baud rate, de-
vice description and device location.
˽ Expert – This driver exposes all device settings, and should be used only
when you are instructed to by Wavetronix Technical Services.
2 Select the driver you want and click OK.